[STORM 1200x] Firmware Update V1.6

Download Version 1.6 here.

This update must be performed with a USB drive.

New updated DMX Chart is required for version 1.5 and later. Download here.

Improved temperature detection and reporting behavior across the fixture, including clearer handling of temperature sensor fault conditions and updated error messaging.
Adjusted low temperature protection behavior to improve fixture operation and stability in cold environments.
Modified fan control behavior to improve stability and reduce unnecessary interruptions during normal operation.
Improved lighting effects logic to prevent excessive power draw while effects are running.
Improved high-speed photography behavior across lighting modes to ensure more consistent output during mode transitions.
Improved error handling behavior so minor or non-critical errors do not interrupt normal fixture operation or the boot process.

Fixed an issue where performing a Factory Reset with Reset Sidus BT set to OFF and Reset CRMX set to ON did not correctly enable CRMX by default as expected.
Fixed an issue where HSI mode did not function correctly when controlled via Sidus Link Pro.
Fixed issues where the fixture could flash or emit light at 0 percent brightness during certain effects or lighting mode transitions.
Fixed an issue where switching lighting modes during high-speed photography could result in unintended flash behavior.
Fixed an issue where RDM functionality could repeatedly restart when a network cable was connected on first power-on.
Fixed an issue where Bluetooth link detection could fail during configuration in specific modes.
Fixed an issue where the DMX address could incorrectly be set to 0.

Minor Update for the Storm 1200x