Skip to content
English
Go to Aputure.com
  • There are no suggestions because the search field is empty.

[NovaP300c-NovaP600c] Power Options

Powering the Nova P300c & P600c

Powering by AC
Powering DC

P300c

nova_p300c_powered_by_ac

  1. Neutrik® powerCON Male Connector
  2. Neutrik® powerCON Female Locking Connector

P600c

nova_p600c_powered_by_ac

  1. Neutrik® power CON Male Connector
  2. Neutrik® power CON Female Locking Connector

* To disconnect the Neutrik® power Con cable, pull back on the release tab on the cable connector, and rotate the connector counter clockwise. Do not pull directly.

Powering by DC

The Nova P300c is not directly compatible with V or Gold Mount batteries, and instead has a 24-48V DC input with a 4-pin XLR connector. As a fixture with a maximum power draw of 360W, this would require up to 15A of continuous power draw at 24V or 7.5A at 48V. The power source can be anything from a large block battery that can output a compatible voltage at the required amperage, or a battery adapter or power station that delivers between 24-48V. The Aputure 2-Bay Battery Power Station will accept 2x 14.4V V or Gold Mount batteries and output 48V DC, which can then be used to power the Nova P300c and is available separately.

P300c

You can also power this light via DC 24V-48V Power from a 3-pin XLR. This can be done via our an Aputure Battery Power Station that supports 48V output, or other power stations or block batteries that are capable of outputting the same voltage.

Screen Shot 2023-07-08 at 3.48.53 PMP600c

Connect 48V 15A DC power supply equipment to supply power through the XLR interface to maintain the operation of the lamp.

Screen Shot 2023-07-08 at 3.47.47 PM

Powering on the Lamp

After connecting the lamp head to an appropriate power source, connect the lamp head and control box with one of the included 5-Pin Male-to-Female XLR Head Cables or the pogo pin of the lamp head (P600c only). Press the power button on the side of the control box to turn the light on and off.

Screen Shot 2023-07-08 at 3.51.21 PM

If Studio Mode is ON/Enabled, the Control Box will power ON whenever power is supplied to the lamp--pressing the Power Button is not required.