⚙️Lighting Configuration & Settings
      Back to home
      1. Help Center
      2. Light Storm 600d
      3. ⚙️Lighting Configuration & Settings

      [LS 600d] Light Configuration and Settings

      LS 600d Light Configuration and Settings

      Setting Up the Light

      Attaching/detaching the protection cover

      Pull back the retaining pin, rotate the cover clockwise, then detach the cover.
      To reattach the cover, insert it into the Bowens mount and rotate counterclockwise.

      ls_600d_ attachingdetaching_the_protection_cover

      Notice: Always remove the protection cover prior to turning on the light. Always re-install the cover when packing it away.

      Attaching/detaching the Hyper-Reflector

      To install the reflector, pull back the retaining pin, insert the reflector into the Bowens mount, and rotate it counterclockwise as shown in the following pictures.

      To remove the reflector, pull back the retaining pin and rotate the reflector clockwise.

      ls_600d_attachingdetaching_the_hyper_reflector

      Setting up the Lamp Head

      If using a 5/8in / 16mm stand (Baby Pin), then mount the Lamp Head onto the stand, and proceed to fix it in place using the T-Handle/Mounting Screw on the Baby Pin Receiver/Mounting Column.

      If using a 1.125in / 28mm stand (Junior Pin), then mount the Lamp Head into the Junior Pin receiver, and fix it in place using the T-Handle on the stand.

      Loosen or tighten the handbrake locking mechanism on the yoke to adjust the fixture's angle of tilt.

      ls_600d_setting_up_the_lamp

      Lightning Clamp Operation Instructions

      1) Clamp the Lightning Clamp onto a light stand.
      2) To attach the control box, rotate the release lever to unlock the quick-release
      baseplate, then mount the control box onto the Lightning Clamp (the release
      lever will automatically spring back).
      3) To remove the control box, grasp it firmly, then unlock the quick-release plate by
      turning the release lever, and detach the control box.

      ls_600d_lightning_clamp_operation

      Specifications

      Weight 670g / 1.48lbs Sizes (L*W*H) 10.35x8.74x12.5cm / 4.07x3.44x4.92in
      The Lightning Clamp can clamp onto square or round pipe with a diameter between 2-5cm or 0.79-1.97in.

      Connect the Lamp Head to the control box

      Connect the Lamp Head to the control box using the LS 600 Series 5-Pin Head Cable.

      ls_600d_connect_the_lamp_head_to_the_control_box

       *Hang the cable using the rope to manage
      and reduce tension on the cable.

      Disconnect the Head Cable by pulling up on the collar on the connector. This will disengage its locking mechanism.